PCBA for driver board(circuit board assembly)

Supply Voltage 3.6V to 7.5V Supply Current (no load) 10mA Input Signal High Voltage 2.0V (min) Inp

The Driver is a specialized multiplexer that uses R/C servo signals as a basis for input control and output signals. The RxMux allows control of 8 R/C servos from two different input signal sources. Signal sources can come from R/C receivers, autopilots or microcontrollers that are connected to the RxMux input pins.                 

The Driver allows control of a set of R/C servos from two different signal sources. Signal sources such as R/C receivers, autopilots, microcontrollers, etc. are connected to Input A and Input B. Standard R/C servos are connected to the Output. Switching between the two sources is accomplished by sending the appropriate width servo signal on the Select input channel (Input A, Channel 8). When a servo signal less than 1.5ms wide is detected, signals connected to Input A are sent to the Output. A servo signal wider than 1.5ms will send connected signals at Input B to the Output. When no servo signal is detected at the Select input, the RxMux will default to connecting Input A to the Output.

The Driver is best used as a component in a well planned system. By itself, it does not perform any failsafe, redundancy, or protection services. Although the it  will default to Input A in the absence of any Select input signal, this is not a reliable failure mode. Most R/C receivers will output some signal even when they are not receiving a valid transmission (this is one cause of servo glitches). The use of PCM receivers with appropriate failsafe programming is recommended. In most applications, an external device must provide the intelligence to determine which input should be selected and send that choice to the Driver

(PCB,PCBA,LED)                                                                                                                                                                          

PCBA for driver board(circuit board assembly)